12 Volt

A popular mid range amplifier from Zetagi, this is more or less the same as the B150 but uses mosfet transistors instead of the single MRF transistor.

Output is probably nearer 80W than the 100W maximum listed in the specs.

A small amplifier for AM/FM only - can not be used on SSB.

Although the amplifier does not have a switch on it, it does have a built-in relay so that you can switch it on/off by putting a switch in the power cable. This allows you to hide the amp away.

A compact amplifier with on/off switch, suitable for use on FM, AM and SSB.

Relay switched, which minimises insertion loss, and can be bypassed using the on/off switch on the front of the amp.

Selectable for AM/FM or SSB.

Compact mobile amplifer with on/off switch.

Mosfet amplifier with maximum output of 100W  (typical output 80W).

Compact mobile amplifier with switchable pre-amplifier.

Mosfet transistors.

Neither the output nor the pre-amp gain are variable.

Compact mobile amplifier with switchable pre-amplifier.

Neither the output nor the pre-amp gain are variable.

A high power broadband amplifier with fixed output power.

The output is a maximum 150W AM/FM and 300W PEP on SSB).

For more details download the instruction manual.

A high power broadband amplifier with fixed output power and 26dB RX preamp.

The output is a maximum 150W AM/FM and 300W PEP on SSB).

For more details download the instruction manual.

The KL 405 is a 180Wmax 12V linear amplifier for use on the 10m Amateur Band, (or other HF bands with the use of a suitable Low Pass Filter). It requires a drive power of 1 to 10W in all modes.

The KL 405 features a six position output power selector via a front panel control and a RX preamplifier with electronic switching, which can be activated via a switch on the front panel. The V version comes with a 80mm heatsink mounted fan.

For full details download the instruction manual.

The KL 405 is a 180Wmax 12V linear amplifier for use on the 10m Amateur Band, (or other HF bands with the use of a suitable Low Pass Filter). It requires a drive power of 1 to 10W in all modes.

The KL 405 features a six position output power selector via a front panel control and a RX preamplifier with electronic switching, which can be activated via a switch on the front panel. The V version comes with a 80mm heatsink mounted fan.

For more details download the instruction manual.

A high power broadband amplifier with variable output power and switchable pre-amplifier (not variable), this is a replacement for the KL500.

The features are all the same as the KL405, but the amplifier uses Mosfet transistors.

The output can be adjusted in 6 stages, from approximately 60W minimum to 250W maximum (AM/FM).

Note: new stock is now in a black case.

For full details download the instruction manual.

A full range HF amplifier with automatic or manual band switching.

Ideal for use with the Yaesu FT817 & FT897 and Icom 703, but suitable for use with any low power HF radio.

• Microprocessor controlled band switching
• 6 internal low pass filters
• LED band indicator
• Baragraph LED output meter
• Auto TX/RX switching
• SSB delay switch
• High SWR protection
• Over temperature protection
• High/Low output level