Build Your Own

Centre piece for wire dipoles.

• 50 Ohms
• SO239 connector  (for PL259 plug)
• Crimp wire connectors
• Strain holes
• Width 92mm

Centre piece for wire dipoles.

A heavier duty version of the one above.

• 50 Ohms
• SO239 connector  (for PL259 plug)
• Crimp wire connectors
• Strain holes
• Width 92mm
• Superior quality construction

Centre piece for wire dipoles.

• 300 Ohms
• Clamp for ribbon cable
• Crimp wire connectors
• Strain holes
• Width 92mm

Replacement centre for centre-fed dipole.

Ideal for homebrew construction.

A black ribbed insulator for use in making homebrew wire antennas.

Available in 2 sizes:

• Small:  approx 7cm x 2.5cm
• Large:  approx 11cm x 3.5cm

A dipole centre with 3/8 thread at the top & bottom.

Used to make homebrew antennas.

A dipole centre with 3/8 thread, with the 2 elements at 90' to each other.

Used to make homebrew antennas such as an inverted-V.

A 50m length of pre-stretched enamelled copper wire for making antennas.

16 gauge (1.5mm diameter)

Can be soldered if the enamel is removed.

Flexweave is a high quality multi-stranded copper wire. It is easy to use, can be soldered, and is extremely strong.

This is the "bare" version, see below for the PVC coated version.

• Length: 50m
• Diameter:  2mm

A thin but very strong guy rope, suitable for both guying masts and in making homebrew antennas.  Stronger than steel. 
We now have this in 50m and 100m spools.

• 1.905mm (0.075in) diameter
• Colour black
• 181.4kg (400lb) strain
• By weight it is stronger than steel
• Has outer protective layer of Dacron
• Will not stretch and not affected by sunlight

A groundplane kit with a 3/8 stud, to allow you to use a standard 3/8 thread mobile antenna as a homebase.

Designed to sit on top of a 1.25" pole, we have found that without being on a pole it will not swr very well.

• 4 x radials
• Length 40cm
• Standard 3/8 thread fitting
• SO239 coax connection
• Fits on 30-38mm mast

A heavy duty mount designed for using a 3/8 thread antenna on a large pole.

The mount will clamp onto a vertical pole and then has a 3/8 thread the antenna.

Also has an addition tag for an earth wire if required.

Coax connection is a standard SO239.

Will fit masts up to 2".

A heavy duty mount designed for making your own dipole antenna using 3/8 thread antennas.

The mount will clamp onto a vertical pole and then has a 3/8 thread connector for a ground plane and a 3/8 thread connector for the driven antenna.

Also has an addition tag for an earth wire if required.

Coax connection is a standard SO239.

Will fit masts up to 2".

A heavy duty mount designed for mounting a SO239 fitting antenna onto a mast.

The mount will clamp onto a vertical pole and then has a SO239 fitting for the antenna.

Also has an addition tag for an earth wire if required.

Coax connection is a standard SO239.

Will fit masts up to 2".