A range of replacement curly leads, extension leads, and cross-over adapters.
A standard replacement curly mic lead.
Length will be listed as either 1.8m or 6ft - either way this would be if the lead was stretched out straight, which is never going to happen.
Available as 3 wire + shield only.
An extra long replacement curly mic lead, approx half as long again as the one found on an average mic.
Length will be listed as either 3m or 10ft - either way this would be if the lead was stretched out straight, which is never going to happen.
Available with either 3 wires + shield or 5 wires + shield.
A thinner than normal replacement curly mic lead.
Designed as a replacement lead for some of the smaller mics - such as the one on the Midland 77-095 etc.
Available in 4-wire only (3 + shield).
The picture shows it next to a standard lead for comparison.
A replacement lead for a speaker/mic complete with a fitted 2-pin plug (2.5mm + 3.5mm).
Different versions are available to order - some with stereo 3.5mm plugs and some mono. State your requirements when ordering.
A genuine replacement lead for the Midland 77-104.
These are unusual because they use a 5-pin din plug with a screw-in collar.
Lead supplied complete with fitted plug.
A shielded straight microphone cable, for making up extensions or adapters.
4 or 9 cores plus an overall lapped screen.
Current stock is black rather than grey as pictured.
A curly microphone extension lead, with a socket on one end and a plug on the other.
Available in 4, 5, 6 or 7 pin.
We can make up cross-over leads for most radios - to allow you to use your mic on 2 different radios.
Just let us know what the mic is wired for and what radio you would like to plug it into, and we will make the adapter to suit.
