Hatchback

Mounts for clamping on a boot or hatchback.

The boot mounts are designed to fit on a "traditional" flat boot. The surface must be close to horizontal, otherwise the antenna will not stand up straight.

The hatchback mount is similar to the boot mount, but the angle of the mount can be adjusted to suit the slope of the hatchback.  Can be fitted on the top of the side of the hatch.

!

Boot Mount
!
boot
Larger picture 

A small 3/8 thread boot mount, to clamp on a standard size car boot lip.

Can be supplied by itself complete with a fitted coax lead and plug  (approx 4m).

Hatchback Mount
!
hatch
Larger picture 

A 3/8 thread mount designed for clamping on a hatchback.

The mount can be swiveled in 2 directions - this allows the mount to be used on either the top or the side of the hatchback, and for it to be adjusted to suit the slope of the hatch.

Can be supplied by itself or complete with a fitted coax lead and plug (approx 5m).

Sirio Trunk-Top 2
B74a
!
trunktop
Larger picture 

A good quality boot mount, designed to fit on a standard horizontal car boot.

The mount has an SO239 fitting (as in picture) but also comes with a 3/8 adapter which screws on top of the mount to allow you to use a standard 3/8 thread antenna on it.

Supplied complete with a fitted coax lead and plug (approx 4m).

MB-400 Hatchback Mount
MB400
!
MB-400 Hatchback Mount
Larger picture 

A black adjustable hatchback mount suitable for use on most hatchbacks and boots.

The mount has a 16mm hole in it and requires a suitable mount and coax to complete it (eg ECH kit). It is held to the vehicle with 4 grub screws.

There is a swivel connection between the base plate and the mount, so you can swivel the mount about both axies.

We have sometimes found that they have put too much paint on these when they made them, and you may need to scrape a little off to ensure a good earth connection.

MB-800 Hatchback Mount
MB800
!
mb800
Larger picture 

A black adjustable hatchback mount suitable for use on most hatchbacks and boots.

The mount has a 16mm hole in it and requires a suitable mount and coax to complete it (eg ECH kit). It is held to the vehicle with 4 grub screws.

We have sometimes found that they have put too much paint on these when they made them, and you may need to scrape a little off to ensure a good earth connection.

Diamond K33 Hatchback Mount
DK33
!
Diamond K33
Larger picture 

A stainless steel adjustable hatchback mount suitable for use on most hatchbacks and boots.

The mount has a 16mm hole in it and requires a suitable mount and coax to complete it (eg ECH kit). It is held to the vehicle with 4 grub screws.

A large locking control allows you to fold the antenna down for entering your garage etc.