Knights Electrocom

Solder-on plug to fit on the bottom of DV type mounts.

These do need a small soldering iron and a steady hand!   If in doubt buy a made up lead.

Wing-nut and bolt to fit a standard DV mount.

Adapter to allow you to fit a standard 3/8 thread antenna onto a DV mount.

Adapter to allow you to fit a DV type antenna onto a 3/8 mount.

Can also be used together with the 3/8 to DV adapter (C52) to make up a "swivel".

A 3/8 thread quick release bayonet adapter.

Fits between the antenna and mount to allow quick removal of the antenna.

Available in standard (middle), large (right) or short heavy duty (left), as in the picture.  The short version has 2 bayonets rather than 1 on the others.

Note: currently only the large version (on the right of picture) is available.

A 3/8 thread swivel adapter.

Used to adjust the angle of an antenna - often used when fitting an antenna onto a vertical surface (eg back of a cab).

The adapter is tightened and adjusted using the supplied alan key.

A 3/8 fitting spring, to fit between an antenna and mount.

Gives rigid antenna some degree of flexibility.

The light duty is very weak and possibly only suits antennas up to about 2ft.

Adapter to fit on a SO239 mount to convert it to accept a 3/8 thread antenna.

Also see below for our 3/8 adapter with swivel (for the same price!)

Made by Sirio to fit on their SO239 mounts (either magnetic or body) to convert them to accept a 3/8 thread antenna.

When fitted on the matching mag mount, you can not even see there is an adapter there!

A radial kit to fit any standard 3/8 antenna.

Simply screw this into your 3/8 base, then screw your antenna into the top of this - and then you have a mobile antenna with 3 radials!

An adapter to fit on the mount which is often found factory fitted on Volvo trucks, to convert it into a standard 3/8 thread mount.