A standard replacement curly mic lead.
Length will be listed as either 1.8m or 6ft - either way this would be if the lead was stretched out straight, which is never going to happen.
Available as 4 wire + shield, 5 wire + shield, and now a 6 wire + shield.
An extra long replacement curly mic lead, approx half as long again as the one found on an average mic.
Length will be listed as either 3m or 10ft - either way this would be if the lead was stretched out straight, which is never going to happen.
Available with either 4 wires + shield or 5 wires + shield.
A thinner than normal replacement curly mic lead.
Designed as a replacement lead for some of the smaller mics - such as the one on the Midland 77-095 etc.
Available in 4-wire only (3 + shield).
The picture shows it next to a standard lead for comparison.
A replacement lead for a speaker/mic complete with a fitted 2-pin plug (2.5mm + 3.5mm).
Different versions are available to order - some with stereo 3.5mm plugs and some mono. State your requirements when ordering.
A genuine replacement lead for the Midland 77-104.
These are unusal because they use a 5-pin din plug with a screw-in collar.
Lead supplied complete with fitted plug.
A shielded straight microphone cable, for making up extensions or adapters.
Available in 5 core (4+shield) or 10 core (9+shield).
May be grey or black.
A curly microphone extension lead, with a socket on one end and a plug on the other.
Available in 4, 5, 6 or 7 pin.
A cross-over adapter which converts Cybernet to Uniden wiring, and visa-versa.
Only available in 4-pin. Please order the adapter below for any other mic/radio combinations.
We can make up cross-over leads for most radios - to allow you to use your mic on 2 different radios.
Just let us know what the mic is wired for and what radio you would like to plug it into, and we will make the adapter to suit.
A replacement plug in lead for the Astatic Echomax 2000 base microphone.
Fitted with a mic plug of your choice.
